7 Series E66 750Li (N62TU) SAL
Release screws (1).
Remove fixture (2) and feed out Bowden cable (3).
Feed Bowden cable (1) out of grommet (2).
Carefully feed Bowden cable (1) with grommet (3) out of vehicle
interior.
Important!
Make sure grommets (2 and 3) are correctly seated (water
ingress).
Installation:
Lay Bowden cable (1) without kinks.
RA Removing and installing/replacing cable for front engine hood locks (to passenge
BMW AG - TIS
12.02.2013 21:04
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -