X Series E53 X5 3.0d (M57) OFFRD
41 00 ...
Embossing chassis number
If the stamped vehicle identification number is removed
during repair work, it must be stamped on afresh.
To stamp on the vehicle identification number, it is
necessary to remove the spring strut at front right.
The special tool kit 41 1 040 for stamping the vehicle
identification number consists of:
Guide plate 41 1 041 (1)
Counter plate 41 1 042 (2).
Place special tool 41 1 042 (2) at bottom on spring strut
support plate.
Place special tool 41 1 041 (1) at top on spring strut support
plate and secure.
Insert stamp numbers 41 1 002 (1) individually in special tool
41 1 031 (2) then emboss VIN.
Note:
In the event of component or body replacement by the garages,
clearly delimit the vehicle identification number at front and rear by
stamping a "+" in place of the BMW emblem.
Observe national regulations.
RA Embossing chassis number
BMW AG - TIS
04.02.2013 00:20
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
