X Series E53 X5 3.0d (M57TU) OFFRD
34 31 505
Removing and installing/replacing master
brake cylinder for DSC
Important!
After completing work: Bleed brake system.
Necessary preliminary tasks:
Read and comply with General Information.
Disconnect battery negative lead.
Remove expansion tank.
Remove heater bulkhead.
Remove battery connection point at partition wall on left.
Unclip Bowden cable for engine hood locking.
Pull wiring harness upwards out of partition wall.
Release nuts (1).
Loosen screws (1).
Remove rubber mount for windshield washer unit (2).
Pull out partition wall.
RA Removing and installing/replacing master brake cylinder for DSC
BMW AG - TIS
05.02.2013 10:16
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -