X Series E53 X5 3.0d (M57TU) OFFRD
41 62 007
Removing and installing rear lid lower section
Remove trim for rear lid lower section.
Disconnect electric plug connections and pull wiring harness
out of rear lid.
Open rear lid until screw (1) is accessible (risk of injury by spring
tension).
Caution!
When second support (2) is released, protect rear bumper by
supporting rear lid.
With rear lid in this position, release screw (1) and insert in bore of
support (2).
Raise front trim of rear lid lower section.
Release screws (1).
Remove trunk lid.
Installation:
Install rear lid lower section at screw locations to hinge. This
dispenses with the need for adjustment after installation.
If necessary, fit rear lid lower section.
Installation:
Tape off hole openings (1) completely with clear adhesive tape
(sourcing reference: BMW Parts Service).
Partially tape off middle opening (measurement A
≤
1 mm to
sealing bead).
RA Removing and installing rear lid lower section
BMW AG - TIS
05.02.2013 11:55
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
