X Series E53 X5 3.0i (M54) OFFRD
Caution!
Different cylinder head bolts for M52TU engine:
M10x95 for engines with cast iron engine block.
M10x110 for engines with aluminum engine block.
Use cylinder head bolts only once.
There must be no oil in the tapped holes of the engine block and
the timing case cover.
Risk of cracking and distorted tightening values.
Put the cylinder head on.
Apply a light coat of oil to washer contact area and thread of new
cylinder head bolts.
Tighten down cylinder head bolts in sequence 1 to 14.
Tightening torque 11 12 6AZ .
Note:
Use special tool 00 9 120 for torsion angle tightening.
Install chain guide.
Insert screws and tighten down screw connection between timing
case cover and cylinder head.
Install camshafts.
Install double VANOS adjustment unit.
Assemble engine.
RA Removing and installing/replacing cylinder head (M52TU / M54 / M56)
BMW AG - TIS
06.02.2013 11:09
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -
