X Series E53 X5 3.0i (M54) OFFRD
11 42 020
Removing and installing complete full-flow oil
filter (M52 / S52 / M52TU / M54 / M56)
Remove intake air housing with air-mass flow sensor.
Unfasten oil filter cover to allow oil to flow out of main flow oil filter
housing and back into oil pan.
This operation is described in the section BMW engine oil service
.
Remove alternator.
If necessary, empty supply tank for power steering.
If necessary, remove supply tank (lines remain connected).
If necessary, remove vane pump for power steering (lines remain
connected).
If necessary, remove alternator drive belt tensioner.
Remove connector for oil pressure switch.
If necessary, disconnect plug for oil temperature switch.
Disconnect oil pressure line for VANOS adjustment unit from oil
filter housing.
Unfasten screws and remove complete full-flow oil filter.
Installation:
Check dowel sleeves for damage and correct installation position.
RA Removing and installing complete full-flow oil filter (M52 / S52 / M52TU / M54 /
BMW AG - TIS
06.02.2013 16:48
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
