X Series E53 X5 3.0i (M54) OFFRD
Release screws.
Tightening torque, 26 11 1AZ.
Installation:
Replace self-locking nuts.
When tightening screws down: Grip each screw and tighten
down nut. This prevents the flexible disk from being subjected
to torsion stress.
Caution!
Do not let propeller shaft fall into joints.
Joints and rubber sleeve can be damaged on constant-velocity
joint.
Grip propeller shaft and release nuts.
Tightening torque, 26 11 6AZ.
Bend propeller shaft downwards at center bearing (1).
Detach propeller shaft from transmission output flange and tie
back to side on vehicle underbody.
Caution!
Exhaust manifold must not rest on stabilizer bar.
RA Removing and installing transmission (S5D 280Z, M54)
BMW AG - TIS
06.02.2013 18:19
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -