X Series E53 X5 3.0i (M54) OFFRD
31 12 631
Replacing rubber mount in left or right control
arm (control arm removed)
Special tools required:
•
31 1 051
•
31 1 054
•
33 3 054
Necessary preliminary tasks:
•
Check ball joint of control arm while installed, replace control
arm if necessary
•
Remove control arm
After installation:
•
Perform chassis alignment check
•
Carry out steering angle sensor adjustment
Press out rubber mount with special tools 31 1 051 , 31 1 054
and 33 3 054 .
Installation:
Keep rubber mount and bore in control arm clean and free from
grease.
Press in rubber mount from chamfered side of control arm bore.
Installation:
Protrusion (A) = 5.75
±
0.7 mm.
RA Replacing rubber mount in left or right control arm (control arm removed)
BMW AG - TIS
06.02.2013 19:26
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -