X Series E53 X5 3.0i (M54) OFFRD
Insert shock absorber in tensioned coil spring.
Check support bearing and spring pad for damage, replace if
necessary.
Attach plate and thrust washer with bearing to piston rod.
Attach support bearing and shim to piston rod.
Replace nut and tighten down with special tool 31 2 210 (grip
piston rod in the process).
Tightening torque 31 31 2AZ
.
Install protective cap.
Important!
Upper and lower coils of coil spring must rest positively on
spring plates!
Relieve tension on coil spring.
Check installation position of gaiter, correct fold if necessary.
After installation:
•
Carry out wheel alignment check if a spring strut with support
bearing was or has been installed without centering pin.
RA Replacing front left or right spring strut shock absorber
BMW AG - TIS
06.02.2013 19:34
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -
