bmw Workshop Repair Guides

BMW Workshop Service and Repair Manuals

3 RA Removing And Installing Or Replacing Left Or Right Rear Brake Caliper|Page 1538 > < 2 RA Removing And Installing Or Replacing Both Rear Brake Disks
Page 1
background image

34 21 745

Removing and installing or replacing left or
right rear brake caliper 

Remove rear wheel.

After completing tasks, bleed brake system.

Apply pedal prop and depress brake pedal slightly. This prevents
brake fluid from emerging from the expansion tank and air from
entering the brake system when the brake lines are opened.

Loosen screws (1). 

Installation:

Tightening torque, 34 21 3AZ .

Disconnect brake hose (2).

Caution!

The brake hose is secured on the upper control arm by a line
holder.

The flaps of the line holder must not be opened. The line holder
must be replaced if it is opened however!

Right:

RA  Removing and installing or replacing left or right rear brake caliper

BMW AG - TIS

06.02.2013  21:13

Issue status (12/2007) Valid only until next DVD is issued

Copyright

Page  - 1 -

3 RA Removing And Installing Or Replacing Left Or Right Rear Brake Caliper|Page 1538 > < 2 RA Removing And Installing Or Replacing Both Rear Brake Disks