X Series E53 X5 3.0i (M54) OFFRD
34 51 527
Removing and installing/replacing hydraulic
unit for DSC
Note:
Read and comply with General Information.
First read out fault memory of control unit and if necessary print
diagnostic trouble code.
Installation:
On completion, carry out following tasks with the DIS (Diagnosis
and Information System):
·
Function check, hydraulic unit
·
Coding for a new control unit
·
Adjustment of steering angle sensor
·
End-of-tape test for new control unit
Bleeding braking system
Load and block brake pedal with pedal support.
M62:
·
Remove equipment carrier.
M54:
·
Remove intake filter housing.
If necessary, detach auxiliary water pump with holder from body.
Disconnect electric connection and press auxiliary water pump to
one side.
Detach plug connection to control unit.
RA Removing and installing/replacing hydraulic unit for DSC
BMW AG - TIS
06.02.2013 21:26
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -