bmw Workshop Repair Guides

BMW Workshop Service and Repair Manuals

4 RA Removing And Installing_replacing Rear Left Or Right Air Spring|Page 1658 > < 3 RA Carrying Out Ride-height-calibration
Page 1
background image

37 12 155

Removing and installing/replacing rear left or
right air spring

Warning!

Danger of injury!

Drain the air spring system before carrying out any work on
the air supply unit, air reservoir, pressure reservoir, air pipes,
air spring struts and air springs! Danger of injury if this
instruction is not complied with!

 

Risk of damage!

The vehicle must not stand on its wheels when the air spring
struts and air springs are depressurized! Otherwise the air
spring struts and air springs will be damaged and later
destroyed during driving!

Extreme cleanliness must be ensured in the connection area
of the pipes during removal and installation. Even the smallest
of dirt particles can cause leakage in the air spring system.

Note:

Read and comply with notes on air spring system.

In a warranty case you must always provide a fault memory
printout, even where there is no fault memory entry, with the
defective part.

Necessary preliminary tasks:

Remove rear wheel

Remove luggage compartment floor trim

Deactivating air spring system:

Raise vehicle on lifting platform.

Remove ignition key

Pull fuse for control unit

RA  Removing and installing/replacing rear left or right air spring

BMW AG - TIS

06.02.2013  21:55

Issue status (12/2007) Valid only until next DVD is issued

Copyright

Page  - 1 -

4 RA Removing And Installing_replacing Rear Left Or Right Air Spring|Page 1658 > < 3 RA Carrying Out Ride-height-calibration