X Series E53 X5 3.0i (M54) OFFRD
37 13 ...
Notes on fitting a new pipe or a screw
connection
Important!
Risk of damage!
Do not kink, twist or crush pipes.
Do not disassemble screw connection!
To avoid leaks in the air spring system, it is essential to avoid
scratches on pipes in particular in the connection area!
Fitting new screw connection:
Insert complete new screw connection consisting of toothed
ring (1), banjo bolt (2) and assembly plug (3) into relevant pipe
connection and tighten down.
Tightening torque 37 12 3AZ
.
Remove assembly plug (3).
Slide new pipe (1) into banjo bolt (2) up to marking.
Check installation position of pipe (1) by pulling back slightly.
Note:
The toothed ring (3) has engaged correctly when the pipe (1)
cannot be pulled back.
Fitting new pipes:
Note:
Pipes are partly integrated in wiring harness.
When replacing faulty pipes, detach them at feed-in to wiring
harness (pipe section remains incorporated in wiring harness).
Secure new pipes along wiring harness with cable ties.
RA Notes on fitting a new pipe or a screw connection
BMW AG - TIS
06.02.2013 21:57
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
