X Series E53 X5 3.0i (M54) OFFRD
41 00 ...
Installing a cavity bulkhead (not expanded)
The following repair represents replacement of a cavity bulkhead.
The following illustrations are intended as a general guide and are
to be applied to the work area in question.
Before this operation, the spare part to be fitted should be
prepared ready for installation (adjusted to fit, cut to size, coated
with zinc dust paint etc.).
Attach cavity bulkhead in specified position (see old part).
Sand contact surface of cavity bulkhead (1) with coarse-grained
abrasive paper (grain 50 - 100).
Clean contact surface (1) with activator for original BMW window
adhesive.
Apply an approx. 15 mm high bead of original BMW window
adhesive to contact surface (1).
Fit, secure and weld up new part.
Warning:
Ensure adequate ventilation over entire processing period.
RA Installing a cavity bulkhead (not expanded)
BMW AG - TIS
06.02.2013 22:38
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
