X Series E53 X5 3.0i (M54) OFFRD
41 62 030
Fitting rear lid upper section
Note:
Gap dimensions E53 serve as basis for fitting work.
Rear lid lower section must be fitted before upper section.
Make unpainted surfaces visible by also moving the hinges. Touch
these up in the appropriate colour.
Do not damage adjoining body parts.
Release screws (1) on hinge.
Fit rear lid upper section according to specified gap dimension.
If adjustment range is not enough, also slacken screws (2).
Tighten screws after adjustment.
Note:
If necessary, slacken screws of lock striker in rear lid lower
section.
Adjust lock striker and tighten screws.
When rear lid upper section is closed, lock striker must not make
contact with or brush against rear lid lock. Look out for scratches.
Check buffer stops in body on left and right for damage and
replace if necessary.
Version up to 12/05:
Turn screw in buffer stop to adjust height of rear lid upper section.
RA Fitting rear lid upper section
BMW AG - TIS
06.02.2013 22:59
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -