X Series E53 X5 3.0i (M54) OFFRD
51 13 402
Removing and installing handle strip (on
trunk lid)
Difference between versions before and after 09/01:
A
Version before 09/01
1
Wide seal over entire handle strip
2
Open microswitch
3
Plug connection
B
Version after 09/01
4
Narrow seal only at top over entire handle strip
5
Plug connection
6
Small seal around plug connection (5)
Installation:
In version (B), closed expansion nuts and shorter
screws (3.5 x 13 mm) must be used.
Release screws (1) and withdraw handle strip (2) somewhat.
Disconnect plug connection (1) and remove handle strip (2).
Installation:
Seal(s) of handle strip (2) must not be damaged.
Tightening torque, 51 13 4AZ
.
Perform function check with trunk lid open.
RA Removing and installing handle strip (on trunk lid)
BMW AG - TIS
06.02.2013 23:14
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -