X Series E53 X5 3.0i (M54) OFFRD
54 13 100
Removing and installing/replacing drip
moulding
Necessary preliminary tasks:
•
Remove complete glass slide/tilt sunroof
•
Remove glass slide/tilt sunroof lid at rear
•
Remove glass slide/tilt sunroof lid at front
Important!
Risk of damage to drip moulding carrier.
Carefully unclip drip moulding (1) upwards out of carrier (2).
Installation:
Attach spring (3) to drip moulding pivot point.
Make sure spring is correctly positioned in drip moulding.
Installation:
Observe installation sequence:
1.
Suspend spring in drip moulding carrier
2.
Press drip moulding onto glass slide/tilt sunroof
3.
Clip pivot point (bearing) of drip moulding into carrier
Check drip moulding for spring tension.
RA Removing and installing/replacing drip moulding
BMW AG - TIS
07.02.2013 01:47
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
