X Series E53 X5 4.4i (N62) OFFRD
33 32 091
Replacing a guide arm
Note:
If during removal operations the guide arm is detached from the
rear axle carrier, it is necessary after reinstallation to carry out a
wheel/chassis alignment check.
Necessary preliminary tasks:
•
Remove rear wheel.
•
Vehicle with coil springs: Remove rear shock absorber from
swinging arm
Slacken nut (2).
Remove guide arm from wheel carrier.
Installation:
Keep guide arm to wheel carrier connection clean and free from
oil and grease.
Replace self-locking nut.
Tighten bolt connection in normal position.
Tightening torque 33 32 4AZ
.
Mark position of eccentric screw to rear axle carrier.
Release nut (1) and remove eccentric washer (3).
Pull out eccentric screw and remove guide arm.
Installation:
Note insertion direction of eccentric screw.
Align eccentric screw by means of marking to rear axle carrier.
Refit eccentric washer.
Replace self-locking nut.
Tightening torque 33 32 5AZ
.
RA Replacing a guide arm
BMW AG - TIS
09.02.2013 15:20
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -