X Series E53 X5 4.6is (M62) OFFRD
Disconnect wiring harness section for engine in control unit box
and place on engine.
Remove positive lead from support point and place on engine.
Disconnect wiring harness section for transmission in control unit
box.
Pull out wiring harness section for transmission and oxygen
sensors and place on engine.
Remove expansion tank,
refer to 17 11 100.
Open cap (1), draw off hydraulic fluid from supply reservoir for
power steering pump. Dispose of hydraulic fluid.
Observe country-specific waste-disposal regulations.
Refit cap (1).
Detach supply reservoir from carrier.
Note:
Lines remain connected.
Note:
Grounding strap (1) is screwed to main flow oil filter housing.
Detach main flow oil filter housing from holder, feed out of carrier
and suspend from engine.
Note:
Lines remain connected.
Provisionally reinstall supply reservoir for power steering pump.
Note:
The engine leans forward once the swivel bearings and output
shafts have been removed.
Support engine with a block of wood (1).
If necessary, secure wood with a cable tie to front axle
support.
RA Removing and installing engine (M62)
BMW AG - TIS
10.02.2013 19:00
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 5 -
