X Series E53 X5 4.6is (M62) OFFRD
Remove left and right swivel bearings,
refer to 31 21 090.
Remove output shafts,
refer to 31 60 000.
Remove bearing pedestal of right output shaft from oil sump,
refer to 31 53 040.
Remove propeller shaft at front,
refer to 26 20 000.
Unfasten steering spindle from steering gear. This task is
described in the work step "Removing and installing steering
gear",
refer to 32 13 060.
Provisionally reinstall left and right swivel bearings and connect
with a screw to spring strut.
Provisionally connect tension strut, control arm and tie rod to
swivel bearing.
Remove front axle differential,
refer to 31 50 000.
As shown in illustration, support front axle support with special
tool 00 2 030 in conjunction with special tool 31 2 220 and a
block of wood.
Note:
Steering gear remains bolted to front axle support. Return
hose of steering gear must not be overstretched when front
axle support is lowered.
Detach front axle support from engine carrier and carefully lower
by approx. 90 to 100 mm.
Tightening torque and installation instructions for front axle
support,
refer to 31 11 001.
RA Removing and installing/replacing upper section of oil sump (M62)
BMW AG - TIS
10.02.2013 19:10
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -
