X Series E53 X5 4.6is (M62) OFFRD
Raise intake air manifold approx. 10 cm and carefully tilt to one
side.
Disconnect oil drain hose from rear cover.
Lift out intake air manifold.
Installation:
Check oil drain for damage.
If necessary, replace oil drain hose and chafe protector.
Ensure it is routed without kinks.
If necessary, remove vent pipe in intake air manifold:
Remove throttle valve.
Remove covers at front and rear from intake air manifold.
Note:
Vent pipe is located with a lug (1) and locked with a retaining
lug (2) in intake air manifold.
Carefully press retaining lug (2) back and push vent pipe out of
bore.
Remove vent pipe (1).
Installation:
Replace seal.
Installation:
Insert vent pipe.
Check fixture (1) and lock (2) of vent pipe in intake air
manifold.
Replace seals.
Install covers at front and rear.
RA Removing and installing intake air manifold (M62)
BMW AG - TIS
10.02.2013 19:45
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
