X Series E53 X5 4.6is (M62) OFFRD
33 32 131
Removing and installing / replacing a steering
knuckle / wheel carrier
Necessary preliminary tasks:
•
Remove output shaft
•
Version with ride-height control:
-
Deactivate and drain air spring/suspension system
-
Remove air spring from wheel carrier
•
Remove brake disk
•
Replacement only: Drive out drive flange for rear axle shaft
•
Except for ride-height control: Remove coil spring
•
Disconnect handbrake Bowden cable from expander lock
•
Remove rear pulse generator from wheel carrier
•
Remove stabilizer link from stabilizer
•
Remove shock absorber from swinging arm
•
Remove integral arm
•
Remove guide arm from wheel carrier
•
Remove control arm from wheel carrier and remove wheel
carrier
After installation:
•
Version with ride-height control: Activate and fill air
suspension system
•
Adjusting handbrake
•
Replacement only: Perform chassis alignment check
Replacement only:
Modify brake carrier/brake guard plate.
RA Removing and installing / replacing a steering knuckle / wheel carrier
BMW AG - TIS
11.02.2013 00:09
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -