X Series E53 X5 4.6is (M62) OFFRD
41 62 005
Removing and installing rear lid upper
section
Remove trims on rear lid upper section. Disconnect electric
plug connections and pull wiring harness out of rear lid.
If the rear window is not removed, the protective cap must be
removed from the socket housing of the rear window wiper
motor.
Secure rear lid upper section against dropping closed.
Unhook gas strut (1).
Release screws (2).
Remove rear lid upper section.
Installation:
Install rear lid upper section at screw locations to hinge. This
dispenses with the need for adjustment after installation.
If necessary, fit rear lid upper section.
Installation:
Raise rubber seal (1) in left and right corners of rear lid upper
section.
Tape off hole underneath with clear adhesive tape (2) (sourcing
reference: BMW Parts Service).
RA Removing and installing rear lid upper section
BMW AG - TIS
11.02.2013 02:34
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
