X Series E53 X5 4.8is (N62-S) OFFRD
34 00 009
Checking brakes on test stand
Note:
1.
Check tyres for damage
2.
Check tyre treads
3.
Check tyre pressure
Follow Brake testing instructions for E53 (X5).
You must follow without fail the guidelines contained in the
operating instructions of the relevant test stand manufacturer.
Important!
Only brake test stands (analyzers) with test speeds of 2.5-
6 km/h may be used.
Before driving onto the brake test stand (dynamic brake
analyzer), switch off the Hill Descent Control (HDC) and
keep it switched off while testing the brakes.
The HDC indicator lamp must not light up!
Note:
It is possible for the HDC indicator lamp to go out or not to light up
even when HDC mode is activated if HDC is temporarily
unavailable on account of high operating temperature.
Production period: from volume production launch up to 09/2003
(model years 2000-20003)
Important!
-
The maximum roller speed must not exceed 7.5 km/h!
-
The maximum test duration for these AWD vehicles must
not exceed 3 minutes for each axle.
-
If the test has to be repeated, it will be necessary to the
drive the vehicle a distance of at least 1 km in order to
achieve sufficient lubrication of the transfer box.
Failure to comply with this instruction may result in damage to
the test stand or to the vehicle.
RA Checking brakes on test stand
BMW AG - TIS
12.02.2013 08:16
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
