X Series E70 X5 3.0d (M57T2) OFFRD
33 32 071
Replacing one upper control arm
Note:
If the control arm is detached from the rear axle carrier, it is
necessary after reinstallation to carry out a wheel/chassis
alignment check.
Necessary preliminary tasks:
•
Remove rear wheel.
•
Deactivate and empty air spring system
Shown on vehicle at rear right:
Remove holders (1) from control arm.
Installation:
Replace faulty holder.
2 = Lead for pulse generator
3 = Only on right side: lead for brake pad sensor
Unscrew nut (1).
Remove control arm (2) from wheel carrier.
Installation:
Keep control arm to wheel carrier connection clean and free from
oil and grease.
Replace self-locking nut.
Tightening torque 33 32 8AZ
.
RA Replacing one upper control arm
BMW AG - TIS
03.02.2013 22:06
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
