X Series E70 X5 3.0Sd (M57T2) OFFRD
Release nuts (1) and remove cover for service opening (2) from
right side of fuel tank.
Disconnect plug connection (1).
Release completely remainder of torque breakoff head (1) with a
screwdriver.
Remove hose clamp from clamping ring (2).
Note:
A flexible extension can be used to release the hose clamp,
Press clamping ring (2) part at open end in direction of arrow and
remove.
Installation:
Make sure that service cover is installed in correct position.
Indentation (2) on clamping ring must line up with raised
section (1) of tank.
Pin on service cover (3) must line up with indentation on
clamping ring.
Hose clip with torque breakoff head (4) must always be replaced.
Tighten hose clip until torque breakoff head (4) breaks off.
RA Removing and installing or replacing fuel gauge sensor (diesel, right)
BMW AG - TIS
05.02.2013 03:00
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -