X Series E70 X5 3.0Sd (M57T2) OFFRD
Note:
The jacking points on the left side are shown.
Align special tools 31 4 051 and 31 4 100 to front axle
carrier.
Support front axle carrier by operating workshop jack 00 2 030 .
Release screws (1, 2).
Installation:
Check threads for damage; if necessary, repair with Helicoil thread
inserts.
Tighten down first screws (1) and then screws (2).
Tightening torque 31 10 1AZ
.
Important!
Risk of damage!
Follow operations must be carried out during lowering:
-
Remove heat exchanger from front axle carrier and tie up
-
Remove stabilizer (conventional) from front axle carrier
and tie back
-
Remove all hydraulic lines on front axle carrier or
stabilizer retaining bracket and tie up
-
Version with active front steering: Disconnect plug
connection and expose connecting line up to power
steering gear
Lower front axle carrier by max. 10 cm.
After installation:
•
Perform chassis alignment check
•
Carry out steering angle sensor adjustment/adjustment for
active front steering
RA Lowering/raising front axle carrier (special tool SWZ00-2040)
BMW AG - TIS
05.02.2013 04:05
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
