bmw Workshop Repair Guides

BMW Workshop Service and Repair Manuals

3 RA Lowering_raising Front Axle Carrier (universal Lifter)|Page 799 > < 3 RA Lowering_raising Front Axle Carrier (universal Lifter)
Page 2
background image

Remove underbody protection at front and rear.

Remove steering gear cover at top left and right.

Remove reinforcement plate.

Partially detach front left and right wheel arch covers (rear section)
in rear area.

Remove lower control arm from spring strut holder.

Version with active steering:

Disconnect plug connection (1) and unclip line (2) from front
axle carrier.

Release nuts and remove screws (1) towards bottom.

Tie up power steering gear (2).

Installation:

Replace screws and nuts.

Tightening torque  32 00 1AZ

.

Engage special tool  31 5 250  with a 2nd person helping
completely on workshop jack  00 2 030 .

Insert special tools  31 5 255  in telescopic supports of a profile
rail pair.

Note:

In a profile rail pair two profile rails are connected to each by
toothing.

 

Insert special tools  31 5 256  in telescopic supports of other
profile rail pair.

RA  Lowering/raising front axle carrier (universal lifter)

BMW AG - TIS

05.02.2013  04:06

Issue status (12/2007) Valid only until next DVD is issued

Copyright

Page  - 2 -

3 RA Lowering_raising Front Axle Carrier (universal Lifter)|Page 799 > < 3 RA Lowering_raising Front Axle Carrier (universal Lifter)