X Series E70 X5 3.0Sd (M57T2) OFFRD
31 60 003
Removing and installing or replacing left
output shaft
Special tools required:
•
31 4 170
Remove front wheel.
Important!
Expand turning lock sufficiently sufficiently to avoid damaging
thread when releasing collar nut.
Release collar nut (1), press brake pedal to floor for this purpose.
Remove left microfilter housing cover
Important!
Use special tool to avoid preliminary damage to ball joint in
upper control arm.
Press plugs out of spring strut dome.
Secure swivel bearing (1) with special tool 31 4 170 in
installation position.
Remove reinforcement plate.
Remove steering gear cover at top and bottom.
Remove lower control arm front spring strut holder and front axle
carrier.
Press output shaft out of drive flange.
RA Removing and installing or replacing left output shaft
BMW AG - TIS
05.02.2013 04:26
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
