X Series E70 X5 3.0Sd (M57T2) OFFRD
Replace collar nut (1), oil collar nut/wheel bearing contact surface
only and tighten down.
No oil permitted on thread of shaft journal or collar nut.
Tightening torque 31 21 2AZ
.
Secure collar nut by positive peening on flat areas of output shaft.
Install front wheel.
After installation:
•
Perform chassis alignment check
•
Carry out steering angle sensor adjustment/adjustment for
active steering
RA Removing and installing or replacing left output shaft
BMW AG - TIS
05.02.2013 04:26
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -