X Series E70 X5 3.0Sd (M57T2) OFFRD
32 41 033
Removing and installing power steering pump
for power steering gear with active front
steering (M57T2)
Warning!
Danger of poisoning if oil is ingested/absorbed through the
skin!
Risk of injury if oil comes into contact with eyes and skin!
Important!
Adhere to the utmost cleanliness. Do not allow any dirt to
enter the hydraulic system.
Seal off hydraulic lines with plugs.
Necessary preliminary tasks:
•
Draw off and dispose of hydraulic fluid from fluid reservoir
•
Remove front underbody protection
•
Remove belt pulley
Release hose clamp (1) and detach suction line from power
steering pump.
Disconnect plug connection on rear side of power steering pump.
Release banjo bolt (2) and detach pressure line from power
steering pump.
Installation:
Replace all sealing rings.
Make sure hydraulic lines are laid without tension and with
sufficient spacing to adjoining components.
Align suction line by way of marking to connection on power
steering pump.
Tightening torque 32 41 4AZ
.
RA Removing and installing power steering pump for power steering gear with active
BMW AG - TIS
05.02.2013 05:06
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -