X Series E70 X5 3.0Sd (M57T2) OFFRD
Release hose clamp (1) and detach suction line from power
steering pump.
Version with active front steering: Disconnect plug
connection (2).
Release banjo bolt (4) and detach pressure line
for Dynamic Drive from power steering pump.
Release banjo bolt (3) and detach pressure line from power
steering pump.
Installation:
Replace all sealing rings.
Make sure hydraulic lines are laid without tension and with
sufficient spacing to adjoining components.
Align suction line by way of "P" marking to connection on power
steering pump.
Tightening torque 32 41 4AZ
(for power steering).
Tightening torque 32 41 9AZ
(for Dynamic Drive).
Remove idler pulley (1).
Release bolts (2) and remove power steering pump towards top.
Tightening torque 32 41 3AZ
.
After installation:
•
Fill and bleed hydraulic system
•
Check pipe connections for leaks
•
If necessary, carry out initial Dynamic Drive operation
RA Removing and installing/replacing power steering pump for power steering gear wi
BMW AG - TIS
05.02.2013 05:07
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
