X Series E70 X5 3.0Sd (M57T2) OFFRD
Release banjo bolt (1) and remove pressure line (2) from power
steering gear.
Installation:
Replace all sealing rings.
Make sure hydraulic line is laid without tension and with sufficient
spacing to adjoining components.
Tightening torque 32 41 5AZ
.
Expose pressure line up to connection on vane pump.
Release banjo bolt (1) and remove pressure line (2).
Installation:
Replace all sealing rings.
Make sure hydraulic line is laid without tension and with sufficient
spacing to adjoining components.
Tightening torque 32 41 4AZ
.
After installation:
•
Fill and bleed hydraulic system
•
Check pipe connections for leaks
•
Perform chassis alignment check
•
Carry out steering angle sensor adjustment/adjustment for
active front steering
RA Replacing pressure line for power steering (M57T2)
BMW AG - TIS
05.02.2013 05:09
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
