X Series E70 X5 3.0Sd (M57T2) OFFRD
33 32 064
Removing and installing/replacing left or right
swinging arm
Note:
If the swinging arm is detached from the integral link/wheel carrier
or rear axle carrier, it is necessary after reinstallation to carry out a
wheel/chassis alignment check.
Necessary preliminary tasks:
•
Remove rear wheel.
•
Deactivate and empty air spring system
•
Remove stabilizer link from swinging arm
Release expansion rivets (1).
Remove cover (2) from rear axle carrier.
Mark position of eccentric screw (3) to rear axle carrier.
Installation:
Replace faulty expander rivets.
Make sure cover is correctly positioned.
Unscrew nut (1).
Remove jointed rod (2) from swinging arm.
Installation:
Sensor lever (3) must point from ride-height sensor to respective
rear wheel.
Replace self-locking nut.
Tightening torque 37 14 6AZ
.
RA Removing and installing/replacing left or right swinging arm
BMW AG - TIS
05.02.2013 05:35
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -