X Series E70 X5 3.0Sd (M57T2) OFFRD
34 00 009
Checking brakes on test stand
Important!
Only brake test stands (analyzers) with test speeds of 2.5-
6 km/h may be used.
Before driving onto the brake test stand (dynamic brake
analyzer), switch off the Hill Descent Control (HDC) and
keep it switched off while testing the brakes.
The HDC indicator lamp must not light up!
Note:
It is possible for the HDC indicator lamp to go out or not to light up
even when HDC mode is activated if HDC is temporarily
unavailable on account of high operating temperature.
Necessary preliminary tasks:
•
Check tyres for damage
•
Check tyre treads
•
Check tyre pressure
•
The brakes must be at normal operating temperature. For this
purpose, gently warm up the brake discs while dry by braking
the vehicle several times.
Important!
For testing, turn on the ignition and make sure the
transmission selector lever is in the "N" position.
Comfort access: insert remote control in ignition lock.
Note:
If the remote control is not inserted in the ignition lock, the "P"
transmission position is selected automatically after approx.
30 minutes.
Failure to comply with this instruction may result in damage to the
test stand or to the vehicle.
RA Checking brakes on test stand
BMW AG - TIS
05.02.2013 05:54
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
