X Series E70 X5 3.0Sd (M57T2) OFFRD
Remove plastic plugs (1).
Important!
Tie brake caliper back and do not allow to hang from brake
hose.
Unscrew guide bolts (1). Withdraw brake caliper backwards.
Installation:
Only clean guide screws; do not grease.
Check threads.
Replace all guide screws which are not in perfect condition.
Tightening torque 34 11 4AZ
.
Important!
When forcing piston back:
-
Pay attention to brake fluid level in expansion tank; brake
fluid that spills over will damage paintwork.
Press back brake pads and piston with special tool 34 1 050 .
Important!
Mark any worn brake pads.
In the event of one-sided brake pad wear, do not change
brake pads round.
Observe minimum thickness of brake pads.
Do not apply grease to brake pad backplate.
Remove outer brake pad (1) in direction of arrow.
Force inner brake pad (2) in direction of arrow off piston and
remove.
Note:
The inner brake pad is seated with springs in the piston or in the
brake caliper housing.
RA Removing and installing/replacing brake pads on both disc brakes (2 pistons)
BMW AG - TIS
05.02.2013 05:58
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
