X Series E70 X5 3.0Sd (M57T2) OFFRD
Clean brake pads.
Check minimum brake disc thickness:
-
Position special tool 34 1 280 at three measuring points in
area (1) and measure.
-
Compare measurement result and lowest value with setpoint
value.
Important!
New brake linings may only be installed if the brake disc
thickness is greater than or equal to the minimum brake disc
thickness (MIN TH).
Note:
The minimum thickness of the brake disc is designed so that it
holds over the service life of a further set of brake pads if it is
greater than or equal to the minimum brake disc thickness (MIN
TH).
Important!
Dust sleeve must not come into contact with Plastilube as this
may cause the dust sleeve to swell.
Check dust sleeve (1) for damage and replace if necessary.
Clean contact surface (2) of brake piston and apply a thin coating
of Plastilube.
Clean contact surfaces (1) of brake pad tee heads/brake caliper
housing and coat with Plastilube.
RA Removing and installing/replacing brake pads on both disc brakes (2 pistons)
BMW AG - TIS
05.02.2013 05:58
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
