X Series E70 X5 3.0Sd (M57T2) OFFRD
Installation:
Insert handbrake cable into brake carrier/brake guard plate.
Sleeve must be inserted up to stop.
Nipple of handbrake cable must audibly snap into place in
expander lock.
Disengage parking brake Bowden cable (1) from holders on left
and right.
Disconnect plug connection (1).
Release screws (2).
Installation:
Tightening torque 34 41 4AZ
.
Release screws (3) and remove holder (4).
Installation:
Tightening torque 34 41 3AZ
.
Feed out actuating unit with parking brake Bowden cables and
cable for emergency release.
After installation:
•
Carry out initial operation/function test in BMW diagnosis
system.
•
Path
-
Function selection
-
Service functions
-
Chassis
-
Parking brake
-
Initial operation/function test
RA Removing and installing/replacing actuating unit with control unit for parking b
BMW AG - TIS
05.02.2013 09:11
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -