X Series E70 X5 3.0Sd (M57T2) OFFRD
Important!
It is not permitted to cut open the protective gaiter to feed
through the pipe (with banjo bolt)!
Cut through pipe (2) and pull out of protective gaiter (1).
Installation:
Seal pipe (2) with adhesive tape.
Thoroughly clean opening in protective gaiter (1).
Insert pipe (2) through opening in protective gaiter (1).
Install new screwed connection.
Important!
Adhere to holder positions and bending radii without fail (see
following positions).
Pipes must run parallel and have sufficient clearance to
adjoining components!
Unclip pipes (1) up to air supply unit from holders.
Note:
Picture serves to show the routing of the pipes.
Unclip pipes (1) up to air supply unit from holders.
Installation:
Make sure slidable holders are correctly positioned. Adhere to
following dimensions without fail.
A = 9.5 cm
B = 6.5 cm
C = 7 cm
D = 6.5 cm
RA Replacing pipes for air springs
BMW AG - TIS
05.02.2013 09:49
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
