X Series E70 X5 3.0Sd (M57T2) OFFRD
37 12 220
Removing and installing/replacing rear active
stabilizer
Warning!
Danger of poisoning if oil is ingested/absorbed through the
skin!
Risk of injury if oil comes into contact with eyes and skin!
Scalding hazard!
This work may only be carried out on an exhaust system
which has cooled down.
Important!
Adhere to the utmost cleanliness. Do not allow any dirt to
enter the hydraulic system.
Close off pipe connections with plugs.
Note:
A film of grease on the anti-friction bearing in no way impairs the
operational capability of the stabilizer.
In a warranty case you must always provide a fault memory
printout, even where there is no fault memory entry, with the
defective part.
Necessary preliminary tasks:
•
Remove left rear wheel
•
Remove stabilizer link on both sides from stabilizer
RA Removing and installing/replacing rear active stabilizer
BMW AG - TIS
05.02.2013 09:51
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -