X Series E70 X5 3.0Sd (M57T2) OFFRD
Release screws (1) and remove protective plate (2).
Tightening torque 37 14 19AZ
.
Important!
Risk of damage!
Adjust minimum distance (A) = 2.5 mm between control
line and oscillating motor.
Mark installation position of control lines to oscillating motor.
Release banjo nuts (1) and remove control lines from oscillating
motor.
Seal control lines and connections of oscillating motor with
sealing plugs.
Installation:
Carry over identification to new component.
Control lines are protected against being mixed up by different
thread diameters on the oscillating motor connection.
Tightening torque 37 14 18AZ
.
Release left and right screws (1).
Remove stabilizer from rear axle carrier and feed out at side.
Installation:
Check anti-friction bearing on both sides for damage; if necessary,
replace stabilizer (observe note at start of repair instruction).
Keep contact face for rubber mount on anti-friction bearing clean
and free from oil and grease.
Check rubber mount for damage, replace if necessary.
Tightening torque 37 14 21AZ
.
RA Removing and installing/replacing rear active stabilizer
BMW AG - TIS
05.02.2013 09:51
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
