X Series E70 X5 3.0Sd (M57T2) OFFRD
41 14 502
Replacing rear left outer wheel arch section
(rear left side panel removed)
Read contents of Body, General.
For stripping and rigging operations, refer to texts on KSD
CD (FR number 41 14 502).
Spot-weld bonding is used on this vehicle. Observe specific
procedure.
Remove or cover those vehicle components in the repair area
which are susceptible to heat or dust.
Use only approved spot-welding apparatus for repairs!
Following new body parts are required (refer to Electronic Parts
Catalogue ETK):
-
(1) Reinforcement, C-pillar, bottom
-
(2) Wheel arch, rear, outer half
-
(3) Shaped parts, wheel arch (not pictured)
Mark severance cuts in accordance with specified measurements
and cut.
Important!
Cut outer metal sheet only.
Measurement a =70 mm below 15 mm dia. bore
Measurement b = 130 mm
Installation:
Weld in reinforcement plates at severance cuts.
RA Replacing rear left outer wheel arch section (rear left side panel removed)
BMW AG - TIS
05.02.2013 10:41
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -