X Series E70 X5 3.0Sd (M57T2) OFFRD
61 31 214
Removing and installing/replacing switch for
Electronic Damper Control (Sport switch)
Necessary preliminary tasks:
•
Remove trim for gear selector switch
Release screws (1).
Raise trim (2) slightly.
Important!
Plug connection (1) must not be disconnected.
Unlock switch for Electronic Damper Control (2) and remove
downwards from trim.
Installation:
Make sure switch for Electronic Damper Control (2) engages
correctly on trim.
Remove gear selector switch carrier (3) .
Disconnect plug connection (1).
Feed wiring harness (2) in direction of arrow out of gear selector
switch carrier (3) and remove switch for Electronic Damper
Control.
RA Removing and installing/replacing switch for Electronic Damper Control (Sport sw
BMW AG - TIS
05.02.2013 15:51
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
