X Series E70 X5 3.0Sd (M57T2) OFFRD
66 53 010
Calibrating reversing camera
Warning!
Risk of injury!
Laser radiation at adjustment unit.
Do not look into the beam!
Laser class 2
As per EN 60825-1: 1994
P
≤
1 mW
Lambda = 632.8 nm
Note:
Calibration of reversing camera must be carried out after the
following work:
•
Removal and installation/replacement of reversing camera
•
Chassis tuning
•
Body repair work at rear end of vehicle
•
Adjustment of rear lid
Important!
Follow instructions and specifications in test module.
To obtain an optimum result, always adhere to the following
conditions:
•
Vehicle standing level on headlight aiming station
•
Correct tyre inflation pressure (see instruction plate on
car).
•
Vehicle is free of load
•
Rear seat bench is unoccupied
•
Do not swap seats during calibration
•
Steering wheel in straight-ahead position
•
Do not move steering wheel
RA Calibrating reversing camera
BMW AG - TIS
05.02.2013 18:31
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -