X Series E70 X5 3.0Si (N52K) OFFRD
Installation:
Seal (1) must always be replaced.
Attach an auxiliary lead (1) to hose pack (2) through service
opening.
The auxiliary lead is pulled through with the hose pack towards the
left and facilitates subsequent reinstallation.
Installation:
Make sure when pulling through the hose pack that the tank
ventilation system in the tank tunnel is not damaged.
Remove sensor unit (1) from fuel tank.
Feed sensor unit (1) with hose pack (2) out of fuel tank.
Installation:
When replacing the sensor unit, modify the end of the auxiliary
lead to the new hose pack and carefully pull in through the tank.
Note:
Illustration shows the tank removed.
Unclip fuel level sensor (1) in direction of arrow from housing and
then slide out of guides in direction of arrow.
Installation:
Fuel level sensor (1) must be felt and heard to snap into place.
RA Removing and installing or replacing fuel gauge sensor (petrol/gasoline, left)
BMW AG - TIS
06.02.2013 11:11
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
