X Series E70 X5 3.0Si (N52K) OFFRD
Warning!
Danger to life!
Mount securing fixture for vehicle on lifting platform to prevent
the vehicle from slipping off or tilting down.
Necessary preliminary tasks:
•
Disconnect battery
•
If necessary, remove fan cowl
•
Remove underbody protection
•
Remove reinforcement plate
Important notes on installation are described in this work step
•
Remove exhaust system.
•
Remove heat shields
•
Remove propeller shaft from front differential
•
Remove propeller shaft
•
Support engine with lifter when removing transmission
Unfasten nut.
Disconnect cable (1).
Installation:
•
Unfasten nut.
•
Adjust cable by means of holder (2) until spacing
A = 1 mm is obtained
•
Tighten nut.
Release screw (1).
Disconnect hydraulic lines (2) to transmission fluid cooler.
Tightening torque 17 22 1AZ
.
Installation:
Replace sealing rings.
RA Removing and installing automatic transmission (GA6HP19Z) N52K
BMW AG - TIS
06.02.2013 17:07
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
