X Series E70 X5 3.0Si (N52K) OFFRD
Installation:
Replace O-ring in output flange.
Check that O-ring is in correct position.
Important!
The propeller shaft may move when the output flange is
pushed on. The retaining ring can thus no longer be fitted.
Installation:
-
Push on output flange
-
Using 2 screwdrivers, press output flange downwards or
output shaft (2) upwards until groove for retaining ring is
completely visible.
-
Fit retaining ring.
Drive a hole into radial shaft seal (1) using a centre punch (2).
Important!
Do not use a drill as drillings may result in transmission
malfunction.
RA Replacing radial shaft seal for output flange (ATC 700)
BMW AG - TIS
06.02.2013 17:32
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
