X Series E70 X5 3.0Si (N52K) OFFRD
31 35 000
Removing and installing/replacing front
stabilizer
Necessary preliminary tasks:
•
Remove front wheels
•
Remove front underbody protection
•
Remove front right wheel arch cover (front section)
•
Remove radiator air duct
•
Remove right brake air duct with holder
•
Remove fan cowl
•
Remove heat exchanger from front axle carrier and tie up
•
Disconnect pressure line for power steering from front axle
carrier
•
Remove both stabilizer links from stabilizer
Release screws (1).
Remove both retaining brackets of stabilizer (2).
Installation:
Align retaining bracket (1) so that tapped holes are situated in
middle of elongated hole.
Tightening torque 31 35 1AZ
.
RA Removing and installing/replacing front stabilizer
BMW AG - TIS
06.02.2013 17:54
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
