X Series E70 X5 3.0Si (N52K) OFFRD
Release hose clamp (1) and detach suction line from power
steering pump.
Release banjo bolt (2) and detach pressure line from power
steering pump.
Installation:
Replace all sealing rings.
Make sure hydraulic lines are laid without tension and with
sufficient spacing to adjoining components.
Align suction line by way of "P" marking to connection on power
steering pump.
Tightening torque 32 41 4AZ
.
Disconnect plug connection (1).
Release screws (2, 5).
Installation:
Reinstall holder (3).
Make sure vent line (4) is correctly seated in holder retaining
clip (3).
Replace aluminium screws.
Observe screwing sequence!
Release bolts (1) and remove power steering pump towards top.
Installation:
Replace aluminium screws.
Observe screwing sequence!
Screwing sequence:
1.
Secure power steering pump with screws
2.
Tighten side screws to 2 Nm
3.
Tighten front screws to 2 Nm
4.
Tighten down front screws to jointing torque and angle of
rotation
Tightening torque 32 41 3AZ
.
5.
Release screws at side and check screw fastening points for
gap freedom
6.
Tighten down side screws to jointing torque and angle of
rotation
RA Removing and installing/replacing power steering pump for power steering gear wi
BMW AG - TIS
06.02.2013 18:44
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
