X Series E70 X5 3.0Si (N52K) OFFRD
33 21 000
Removing and installing/replacing left or right
output shaft
Remove rear wheel.
Important!
Expand turning lock sufficiently to avoid damaging thread
when releasing collar nut.
Release collar nut (1), activate parking brake for this purpose.
Installation:
Replace collar nut, oil collar nut/wheel bearing contact surface
only and tighten down.
No oil permitted on thread of shaft journal or collar nut.
Tightening torque 33 41 1AZ
.
Secure collar nut by positive peening on flat areas of output shaft.
Remove rear axle differential.
Important!
Secure output shaft against falling out.
Do not damage dust covers (1, 2) when setting down output
shaft.
Press output shaft out of drive flange and remove towards centre
of vehicle.
RA Removing and installing/replacing left or right output shaft
BMW AG - TIS
06.02.2013 19:09
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
